ElCabong Posted December 10, 2021 Share Posted December 10, 2021 I added two 5x2 blocks to the length of my base and could not place the work base there. So I added two more 5x2 blocks. It's still would not let me place it there. I don't understand what's going on.I know would work in a19. Link to comment Share on other sites More sharing options...
Pernicious Posted December 10, 2021 Share Posted December 10, 2021 Are any of those 5x2 blocks visually deceiving? E.g. plates which only take up what appears to be a few cm, but the block is then used? I mistakenly did a base design where I had the plate on the bottom of the bock, o anything I put on top of it "floated" 90% of a block off the ground. Same thing happens with like poles, walls, switches, torches etc. Link to comment Share on other sites More sharing options...
ElCabong Posted December 10, 2021 Author Share Posted December 10, 2021 18 minutes ago, Pernicious said: Are any of those 5x2 blocks visually deceiving? E.g. plates which only take up what appears to be a few cm, but the block is then used? I mistakenly did a base design where I had the plate on the bottom of the bock, o anything I put on top of it "floated" 90% of a block off the ground. Same thing happens with like poles, walls, switches, torches etc. No these are valid blocks that I placed and upgraded to wood blocks Link to comment Share on other sites More sharing options...
Sydious Posted December 10, 2021 Share Posted December 10, 2021 Standing to close when trying to place maybe? Link to comment Share on other sites More sharing options...
ElCabong Posted December 11, 2021 Author Share Posted December 11, 2021 42 minutes ago, Sydious said: Standing to close when trying to place maybe? I don't think so. I've made a lot of work stations. Never had this problem before. Link to comment Share on other sites More sharing options...
Pernicious Posted December 11, 2021 Share Posted December 11, 2021 Screenshot would help Link to comment Share on other sites More sharing options...
Maharin Posted December 11, 2021 Share Posted December 11, 2021 Is it a height issue? Meaning, is your ceiling too low to place them? Try it in a base with a higher ceiling to see if that affects the outcome. Link to comment Share on other sites More sharing options...
Beelzybub Posted December 12, 2021 Share Posted December 12, 2021 On 12/10/2021 at 3:10 PM, ElCabong said: these are valid blocks that I placed and upgraded to wood blocks A half block or plate are valid blocks that would prevent you from placing a workstation. Link to comment Share on other sites More sharing options...
ElCabong Posted December 12, 2021 Author Share Posted December 12, 2021 The problem went away when I built a roof over the ledge I was trying to place the workstation on. I have placed workstations out in the open on a ledge before. So I'm not sure what was going on. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now