Jump to content

Brightness setting on lights


Recommended Posts

I often use basic bulbs as "indicators" to show that something has power. But sometimes I have too many in a small area which causes that area to be so overly bright that it is just stupidly unpeasant to look at.


I wish I could set them to a lower value, eg 20%.


How hard would it be to create a light-bulb with a brightness setting?


If that is difficult, then how about just version of the basic bulb that gives a very low light (and ideally uses less power).


What would have been even better would be an indicator panel that shows say up to 4 other specific things to show whether they are on or off ... but that Iimagine is in a different league.

Link to comment
Share on other sites


This topic is now archived and is closed to further replies.

  • Create New...