Change Trip Wire Post Triggers

[blugold1]

Let’s assume you have a trip wire setup that powers instantly when triggered and runs for one minute.

 

If one zombie walks through it, the one minute timer starts. If another zombie walks through it 10 seconds later, that one minute timer does not start over. It will be at 50 seconds remaining. The trip wire cannot be triggered again until the full one minute timer expires.

 

Where this causes issues is when a zombie walks through a trip wire a few seconds before it expires. The traps that should be activated, then shut off until another zombie trips it again. The zombie that just passed the trip wire gets a free pass.

 

Can they please be modified so every time a zombie crosses a trip wire, the timer starts over?

 

Also, why can’t trip wire posts be repaired? At least, I’ve been unable to find a way to repair them.