Jump to content

Question about the multiblock on the door class


n2n1

Recommended Posts

When i create a door(and use this class) there is a problem when the inscription "press E to open" only within one block.

 

"MultiBlockDim" size is set to cover the entire prefab, also the tag "T_Mesh_B" is set.

 

creating a door followed this lesson

 

I asked questions in this thread

https://7daystodie.com/forums/showthread.php?72130-Creating-and-Exporting-Models-from-Unity-for-use-in-7D2D&p=861629&viewfull=1#post861629

 

I have checked similar doors in other mods and have not found this problem....:(

Link to comment
Share on other sites

  • 4 months later...
When i create a door(and use this class) there is a problem when the inscription "press E to open" only within one block.

 

"MultiBlockDim" size is set to cover the entire prefab, also the tag "T_Mesh_B" is set.

 

creating a door followed this lesson

 

I asked questions in this thread

https://7daystodie.com/forums/showthread.php?72130-Creating-and-Exporting-Models-from-Unity-for-use-in-7D2D&p=861629&viewfull=1#post861629

 

I have checked similar doors in other mods and have not found this problem....:(

 

curious if you ever discovered what was going on in this?

I am having some issues in multiblock usage as well.

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...